Skip Navigation Website Accessibility

GO! Cupcake Die

AQ Cutting Mat Required: GO! Cutting Mat, 6 in. x 12 in. 2 Pack (15.2 cm x 30.4 cm) Item 55204

How to Die Cut Cupcake Shapes:

Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué.

  • Cupcake Top-Rounded: Cut and fuse 3" x 4 3/4" rectangles. Cut eight pointed tops across the width of fabric. One yard of 40" wide fabric cuts 96 pointed tops. 
  • Cupcake Top-Pointed: Cut and fuse 2 5/8" x 4 3/8" rectangles. Cut nine rounded tops across the width of fabric. One yard of 40" wide fabric cuts 117 rounded tops. 
  • Cupcake Bottom: Cut and fuse 4" x 4 1/4" rectangles. Cut 10 cupcake bottoms across the width of fabric. One yard of 40" wide fabric cuts 80 cupcake bottoms.

Why Quilters Love the GO! Cupcake Die:

  • Mix and match the die’s two cupcake tops with multiple-fabric bottoms to create very sweet quilts. Perfect for baby and wedding gifts, appliqué quilts, home décor and so much more! 
  • No templates required. The GO! Cupcake die includes three applique shapes that are typically difficult to cut by hand. 
  • Great value! Get multiple shapes for the price of one GO! Cupcake die. 
  • Quickly and easily cut four of each prefused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric). 
  • Cut cupcake shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more! 
  • A great way to use up scraps. 
  • Free pattern downloads available to get you started. 
  • Charm Pack-friendly.

AccuQuilt Benefits: 

  • Cut so much more fabric in less time. 
  • Get accurate cuts every time -- No slipping rulers or mistakes
  • Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
  • Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
  • Safe to use -- No blades come anywhere near your fingers

Die Tips: 

  • With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
  • Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
  • Use good quality fabric to reduce fabric stretch. 
  • It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct. 

Contact Us